1996) Endotoxins were extracted (Douwes et al 1995) and

1996). Endotoxins were extracted (Douwes et al. 1995) and

analyzed by a quantitative kinetic chromogenic Limulus amoebocyte lysate assay according to the manufacturer’s instructions (Cambrex Bio Science Walkersville, Maryland, USA). The test was done during two consecutive weeks. Blood sampling and analyses Blood samples for Belnacasan solubility dmso the determination of the pneumoproteins CC16, SP-A, and SP-D were collected after at least 1 day of exposure, between 1 and 2 PM, directly after the personal exposure measurements were ended. Whole blood was collected by venipuncture in 10-ml tubes without additives (BD Diagnostic, Plymouth, UK). Serum was obtained after coagulation for 60 min this website at room temperature and centrifugation for 15 min at 3,000 RPM. The serum samples were then frozen in NUNC® cryotubes at –25°C no more than 2 h later and kept frozen until analysis. The concentrations of the pneumoproteins were determined at the Department of Occupational and Environmental Medicine, University of Gothenburg. CC16 was determined using the commercially available Human Clara Cell Protein ELISA kit from BioVendor (BioVendor Laboratory

Medicine, Inc., Brno, CzechRepublic) according to the manufacturer’s instructions. Determination of SP-D was performed using the SP-D ELISA kit from BioVendor, according to the protocol supplied by the manufacturer. SP-A was analyzed by sandwich ELISA as described in detail previously (Ellingsen et al. 2010). In short, the primary antibody was AB3422 (Millipore, Billerica, MA, USA); the secondary antibody was HYB 238-04 (Antibody Shop, Gentofte, Denmark). Statistical methods Continuous variables were log-transformed to achieve normal distribution when the skewness exceeded 2.0.

Thus, the concentrations of SP-A and exposure variables were log-transformed. For log-transformed variables, the geometric mean (GM) is presented, while the arithmetic mean (AM) is otherwise used. Parametric statistical methods were used. Student’s t test was used for two-group comparisons. One-way analysis of variance (ANOVA) was used when more than two groups were compared, thereafter subcommand LSD (least significant difference 17-DMAG (Alvespimycin) HCl test) in order to separate which groups that were different from each other. Univariate associations between variables were assessed using least square regression analysis, yielding Pearson correlation coefficients (r p) as the measure of correlation. Multiple linear regression analysis (stepwise backwards procedure) was used to assess associations between dependent variables and several independent variables simultaneously. General linear models of relevant parameters were used to calculate adjusted group estimates. The level of significance was set at 0.05 (two-tailed). The statistics were calculated with SPSS 18.0.

Comments are closed.