M. perniciosa strain CEPEC 1108 (designated CP03) of the C biotype of M. perniciosa was also used for morphological studies. Mycelial starter cultures from the culture collection of the Cocoa Research Center (CEPEC, Ilhéus, Bahia, Brazil) were grown on PDA (Potato Dextrose Agar) for three weeks in the dark, at room temperature. Basidiomata were obtained from mycelial mats, as described by Griffith and Hedger [7] with the modifications

introduced by Niella et al. [15]. A solid bran-based medium was prepared (50 g wheat flour; 40 g vermiculite; 6 g CaSO4 × 2H2O, 3 g CaCO3 and 120 mL distilled water; moisture content 65–70%, pH 7.0–7.5). The mixture was placed in Petri dishes, covered with aluminum foil and autoclaved selleck products twice for 90

min (121°C). The cooled medium was inoculated with two 5-mm disc plugs from 1 to 3-week-old mycelium, grown on 2% PDA medium. Cultures were incubated at 25°C in the dark. After mycelia had completely colonized the surface of the bran medium (usually 3–4 weeks), cultures were covered with a 5-mm thick layer (5–10 g per culture), composed of 200 g coarse peat, 50 g CaCO3, 50 g vermiculite and 125 mL distilled water (moisture content 70–75%, pH 7.0–7.5). These cultures were incubated for 3 to 4 Talazoparib research buy weeks at 25°C in the dark and then hung vertically in a broom chamber [14], and maintained at 23°C ± 2°C for 75 d. Irrigation consisted of spraying de-ionized water daily for 7 h with a 12 h period of fluorescent warm white light (65–80 W). After 30 d in the chambers, the irrigation was suspended for 7 d, a procedure selleck kinase inhibitor routinely used to induce fructification. Microscopic analyses

The preparation of mycelial mat samples for light microscopy was conducted according to standard histological methods [66]. For histological studies of basidiomata development at various stages, samples were fixed after collection by dehydration in a gradient of ethanol/tertiary butyl alcohol series (50 to 100%) for 2 h each, and thermally embedded in paraffin (melting point 56.5°C; Paraplast plus; Fisher Sci. Co., Pittsburgh, USA). The embedded tissues were radially cut (5 to 14 μm thick) with a rotary microtome. Serial sections were thermally mounted on learn more microscope slides coated with Haupt’s adhesive and 4% formalin [67]. The sections were immersed/rinsed three times in 100% xylene and passed through a series of xylene and absolute ethyl alcohol (EtOH) 1:1, absolute ETOH, and 70% ETOH. Some sections were stained with Pianeze III-B stain [68, 69]. This procedure specifically stained soluble and insoluble proteins red with acid fuchsin and non-living material, i.e. polysaccharides and phenol, green to dark green [35]. Other sections were stained for 1 h with 1% astra blue and then for 1 h with 1% safranin.