The effect of solvents on β-sheet formation showed that films treated with different alcohols exhibit the signature of the β-sheet conformation (silk II structure) at each amide peak: amide I, which reflects the stretching of C=O group along the SF backbone (shifted from ~1650cm−1 to 1630cm−1). The amide II, which originates from N–H deformation, shifts from ~1544 to 1536cm−1. As seen from Table 3, isopropyl alcohol treatment also

gives good crystallizing effect. Table 3 Effect of different Inhibitors,research,lifescience,medical solvents on β-sheet formation. The content of SF and glycerin has an impact on the FTIR signal. Higher SF (SF/G 1:1) content showed higher fibroin-specific signal change for amide I after cast-treatment. Interestingly, the untreated films (SF/G

1:1) also demonstrated the crystallizing effect indicating that glycerin could induce the formation of β-sheet (Table 3). 3.3. Preparation of Drug-Loaded Films A mixture of Inhibitors,research,lifescience,medical dialyzed SF solution with predetermined amount of gelatin mass and a model drug was cast on a polystyrene weighing boat to prepare SF films. Cast films were treated with methanol, ethanol, and isopropyl alcohol or exposed to water vapor. Gelatin mass was prepared from gelatin, water, and plasticizer (glycerin) Inhibitors,research,lifescience,medical by initially mixing water and plasticizer with gelatin granules followed by heating at ~60°C until a clear gel was obtained. 3.4. Development of a Sustained Release Matrix SF-containing compositions were prepared, using naproxen sodium, as a model drug and presented in Table 4. These compositions are calculated based on weight after the films and matrixes have completely dried, before performing Inhibitors,research,lifescience,medical dissolution testing. Table 4 Composition of naproxen sodium experimental samples. The characterization of naproxen release from SF-containing matrixes and films was Inhibitors,research,lifescience,medical performed at pH 7.4. Drug release from amorphous carrier (http://www.selleckchem.com/products/BI6727-Volasertib.html control film) was characterized by an initial burst exceeding 75% of the theoretical amount of naproxen in 5 minutes demonstrating immediate

release of the model drug. For SF-containing films the initial burst was markedly reduced (~60% in 5 minutes). Studies (Figure 2) indicated that the time needed to achieve over CYTH4 80% dissolution for naproxen-loaded films is 15 minutes as opposed to 5 hours for the SF-containing matrix. These results demonstrate the formation of crystalline SF network in silk and gelatin blends which significantly retard the release of naproxen compared to amorphous gelatin. Figure 2 Dissolution profile of naproxen from SF-containing matrix (♦) as compared to SF () and non-SF (■) film. 3.5. Development of SF Microparticles for Controlled Release Although the SF/gelatin/glycerin blends described above demonstrated feasibility for use as a controlled drug delivery system, another approach utilizing microparticles containing only SF and water was explored.