The Raman spectra were obtained using a Senterra R200-L Raman spectrometer (Bruker Optik GmbH, Ettlingen, Germany) with a 514-nm line of https://www.selleckchem.com/products/carfilzomib-pr-171.html laser source. Fourier transform infrared (FTIR) spectra were recorded using a Vertex 70 vacuum FTIR spectrometer (Bruker Optik GmbH) and scanned from 4,000 to 400 cm−1 with KBr as background. Thermogravimetric analysis (TGA; Pyris 1, PerkinElmer, Waltham, MA, USA) was performed under a highly pure nitrogen atmosphere with a heating rate of 1°C to 10°C/min from 30°C to 700°C. The films with 5-mm width and 4- to 5-cm length were measured by dynamic mechanical analysis (DMA; TA-Q800, TA Instruments, Newcastle, DE, USA) at the room temperature. A

four-probe detector (RTS-8,

4 PROBES TECH, Guangzhou, China) was used to measure the sheet resistance of the films. Results and discussion The modified Hummers method had been used to prepare graphene oxide. By sonicating the graphene oxide in water, graphene oxide sheet aqueous solution was obtained. From the tapping-mode AFM image as shown in Figure 3, it is observed that the thickness of the obtained graphene oxide sheet is approximately 1.05 nm, which indicates that the graphene oxide can be easily exfoliated into single layer by the oxidation and sonication Selleckchem SB431542 treatment [40]. The graphene oxide films with a large area were fabricated by casting method. The graphene oxide sheets can be easily assembled into graphene oxide films by volatizing water in the oven at 80°C. PTFE, a hydrophobic substrate, is used Cediranib (AZD2171) to make sure that the films are easily peeled off and the large-area free-standing films fabricated. As shown in Figure 1a, the yellow-brown paper-like films with a semitransparent characteristic are obtained. In order to obtain the graphene films, ascorbic acid, as an excellent reducing agent,

has been used here to reduce the graphene oxide films [39]. As a result of the reduction process, the opaque graphene films with black color (Figure 1b) are obtained. Excitingly, the morphology of the graphene films can be perfectly maintained after the reduction process (Figure 4a,b), which suggests that this facile and novel method is suitable for the large-scale production of graphene films. For the improvement of the conductivity of the films, Ag particles have been in situ introduced during the process of the reduction reaction. The morphology of the graphene-Ag composite films has been observed by SEM, as shown in Figure 4. It can be found that the films are decorated with Ag particles with an average particle size from approximately 20 nm to approximately 1 μm (Figure 4c,d,e,f,g). When the mass ratio of AgNO3/graphene oxide is 1:75, these Ag particles with a size of about 20 nm were distributed uniformly at the surface of the composite films (Figure 4c).