This process is also superior in terms of the % theoretical sugar maximum and cost/time effectiveness [5], [17] and [21]. With the exception of the yield from overwork (over 96 h), Fig. 2 shows that the ethanol produced by fermenting WEBI-treated RS increased within 24 h of SSF and reached its maximum value after 48 h. After 48 h, the ethanol concentration, production

yield, and productivity of the WEBI-treated straw Osimertinib molecular weight were 9.3 g/L, 57.0% of theoretical maximum, and 0.19 g/L h, respectively. When the untreated straw was used in SSF, these values were 2.9 g/L (17.9% of theoretical maximum) and 0.06 g/L h, respectively. When only EBI was used, the maximal ethanol yield was determined to be 47.5% after 48 h. Interestingly, the ethanol LY294002 cost yield from the WEBI system was approximately 3.2 times higher than that of untreated straw after 48 h of

SSF, which is likely due to the acceleration of the cellulolytic process based on the enhanced digestibility of pretreated lignocellulose. In addition, regardless of whether the straw was treated or untreated, a low level of glucose (<0.3 g/L) was observed for a brief period during the SSF (Fig. 2). This value may have been higher during the release of glucose from the substrate than during the uptake of glucose by the fermentable yeast. Lastly, unlike the untreated straw (<0.1 g/L), the levels of acetic acid in the pretreated biomass were not detected with significant variance throughout the SSF period. In conventional pretreatment using an ammonia-soaking system, the production of ethanol via fermentation was 0.52 g/L h after 24 h and 0.26 g/L h after 48 h, http://www.selleck.co.jp/products/ch5424802.html respectively [13]. The fermentation yields during the above study are not

greater than the yield (0.31 g/L h) observed after 24 h of SSF in the present study (Fig. 2). Furthermore, 9.8 g (62.0% of maximum) of ethanol in a statistical-based optimal biosystem was finally obtained after 144 h of SSF [3], which was not more than the WEBI-level (10.6 g; 67.1% of maximum; Fig. 2). Unlike EBI pretreatments, WEBI-pretreated RS following the water soaking program revealed ultrastructural changes on the lignocellulosic surface (Fig. 3). The structures of the untreated surfaces were smooth and flat, whereas the pretreated surfaces had partially degraded face, scars, and cracks. Notably, the WEBI-pretreated rice straw had non-spherical protrusions, possibly due to reactive oxygen species (ROS), such as hydrogen peroxide, which induce oxidative cascades between electrons and water molecules (Fig. 3c). When compared to EBI pretreatment under optimal conditions (0.12 mA – 80 kGy – 1 MeV), changes in the crystalline portion were hard to distinguish by WEBI within the error range.